Vpn autoconnect windows 106/24/2023 The AutoTriggerDisabledProfileList property located in HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\RasMan\Config is a list that will maintain the profiles within the list, in a disconnected state, surviving reboots, and whatnot. Registry location of AutoTriggerDisabledProfileList In any case – what happens is, that this lands the VPN connection on a list in the registry called AutoTriggerDisabledProfileList which is a REG_MULTI_SZ property type that you might be interested in clearing out the Always On VPN connection name from. This might have happened because the user manually disconnected the user tunnel at some point in time, or because of something that is yet to be explained. Some hacks to fix this, include scheduling the “rasdial ” command to re-establish the connection, but wouldn’t you rather know why it has stopped auto-connecting? Why is it not auto connecting then? Which just scratches the surface of some of the woes you will have with this technology…īut setting all the configuration issues aside for a moment… I think that anyone working with Microsoft Always On VPN infrastructure and client configuration has run into an issue where user tunnel connections don’t always auto-connect – despite having configured “AlwaysOn” in the ProfileXML or Intune configuration policy. # Adding trigger even it already exists seems to be necessary to get it to trigger after rasdial /disconnectĪdd-VpnConnectionTriggerApplication -Name $vpnProfileName –ApplicationID "C:\Windows\explorer.The Microsoft Always On VPN Solution that is pushed by Microsoft as the successor to DirectAccess, is a great tool for remote workers and admins alike because it’s always on – or is it?ĭespite the high level of skills required to implement this technology, many try out their luck with the official documentation from Microsoft, only to end up at the troubleshooting section at. Will trigger on process launch as well as if it is already running. # Add trigger to a process that is certain to be running. Remove-ItemProperty HKLM:SYSTEM\CurrentControlSet\Services\RasMan\Config -name AutoTriggeringDisabled Set-ItemProperty HKLM:SYSTEM\CurrentControlSet\Services\RasMan\Config -name AutoTriggerDisabledProfilesList -Type MultiString -Value $disabledProfiles $disabledProfiles = $disabledProfiles | where $disabledProfiles = ](Get-ItemPropertyValue HKLM:SYSTEM\CurrentControlSet\Services\RasMan\Config -name AutoTriggerDisabledProfilesList) Re-enable auto-triggering and start the VPN connection: # Remove Disabled Profile Get-VpnConnection | select Name, IsAutoTriggerEnabled, ConnectionStatus # Rasdial disconnect will turn off AutoTriggering $ip = $(Resolve-DnsName -name $vmName | where section -eq answer).IPAddressĪdd-VpnConnectionRoute -Name $vpnProfileName -DestinationPrefix "$ip/32" # Name of VM restricted to VPN IP addresses Optional example to show how to setup split tunneling: # Enable split-tunneling to a specific address Set a specific VPN profile name here or use the first one that comes back from Get-VpnConnection: $vpnProfileName = Get-VpnConnection | select -first 1 -ExpandProperty Name The below seems to work to re-enable auto-triggering. The problem was that rasdial /disconnect disables AutoTrigger settings. But after configuring split tunneling to connect to a VM locked-down to VPN IP addresses, the VPN connection needed to be disconnected/reconnected to take effect. The "Connect automatically" checkbox in Windows VPN settings was working well for me.
0 Comments
Leave a Reply. |